Page: 16
SmartPad LCD
¥
© 2006 Xantech Corporation
Connect the 2.1mm Coaxial plug of the power supply into the 16VDC input of SPLCD Connecting Block
(Model #SPLCDCB10).
IR Wiring:
Wire 4-Conductor 18AWG from the CSPLCD’s IR OUT, GND, STATUS (optional) and +16VDC terminals
back to the appropriate terminals of the SPLCD Connecting Block. See
Figure 8
for wiring examples.
283M
Blink-IR
Mouse Emitter
283M
Emitter
283M
Emitter
VCR
Satellite Receiver
AV
Receiver
SPLCD-CB
Amplified Connecting Block
EMITTERS
16 VDC
IR
RCVR
SPLCD-CB
AMPLIFIED
CONNECTING BLOCK
®
+12 VDC OUT
GND
STATUS
IR IN
SPLCDPS1
16VDC Power Supply
(To Un-Switched AC Outlet)
SPLCD
ONL
Y
+16 VDC
GND
STATUS
IR IN
Figure 8 – Power Supply and IR Output Wiring (Model # SPLCDCB Shown)
Caution:
Remember, the STATUS output can be either an Input (5-30VDC from remote device) to
trigger a Macro within the CSPLCD give LED indication of a unit or Zones power status, or it can be an
OUTPUT (+12VDC from the CSPLCD) to trigger some other external device. This is important to note
before STATUS wiring is made between the CSPLCD and the other device. DO NOT CONNECT AN
OUTPUT TO ANOTHER DEVICES OUTPUT!
E
XTERNAL
IR I
NPUT
W
IRING
:
(Figure 3 – 20)
A 4-Terminal WECO connector is provided for convenient wiring of external IR Receivers (780-90, 291-10,
490-90, etc…) to the CSPLCD display. IR commands received here will be rebroadcast and passed out the
Xantech IR Bus of the CSPLCD (Fig. 3 – 19). RC68+ commands received here (of the proper Code Group)
can trigger internal IR or RS232 Macros programmed into the CSPLCD display.
x
+12VDC Output:
This is a voltage reg12VDC output signal derived internal to the CSPLCD unit
from the 16VDC supply voltage. Use this output to power the external IR Receiver. The 12VDC output
can power a load of up to 100mA maximum (80mA effective load).
Caution: This is a 12VDC OUTPUT only. Do not connect a 12V power source to this point. This is
only an OUTPUT to power an external IR Receiver.
Содержание CSPLCD39G
