Page: 42
SmartPad LCD
¥
© 2006 Xantech Corporation
3. Left Click and Drag the “Delay 2 Sec” line and drop it between any two commands you have placed on
the Command List.
NOTE:
As you drag a command upward in the list and you want the command between two existing
commands, drop it on the lower one. As you drag downward, drop it on the upper one.
R
EPEAT
C
OMMANDS
Commands can be repeated to extend the amount of time the command is being issued. This is sometimes
necessary for STOP commands or any commands that seem to be intermittent with a short button press.
1. To repeat an IR command for any reason, just use the arrows to set the number of times to repeat a
code.
2. Double Click in the word “REPEAT”. This will place a “cycle” symbol and the words “Repeat 3 Times” (if
3 is selected) at the bottom of the Macro Command List.
3. Left Click on the “Repeat 3 Times” line and drag it directly ahead of the code to be repeated.
EDITING COMMANDS (IN THE MACRO COMMAND LIST WINDOW)
Right-clicking on a command placed in the Macro Command List window will bring up a pop-up menu allowing
an individual command to be deleted, routed to a specific Zone emitter output or to a Source emitter output (see
Figure 27
above). Each of the functions available are described below.
D
ELETE
Highlighting a single command in the Macro Command List and
right-click
the command with the mouse. Select
Delete
from the pop-up menu will remove the command from the Macro Command List.
T
ESTING
C
OMMANDS
P
LACED ON THE
V
IRTUAL
CSPLCD
Commands placed under buttons in the Virtual Keypad window may be tested prior to downloading to the
CSPLCD Display. To test commands, the Universal Dragon PC must be connected to the front panel COM
PORT or USB Port and emitters must be placed in the proper IR Emitter output ports of the Connecting Block.
1. Select the appropriate GTL button in the SmartPad LCD™ Systems window with the IR codes placed
under it to test. (i.e. The PLAY button:). The button should now appear selected.
2. Click on the TEST button located in the upper-middle of the CSPLCD Macro Command List window.
Commands listed under the Macro Command List for that selected Command should now be executed
in order of appearance out of the proper Ports on the connecting block connected to the IR output of the
CSPLCD Display.
Содержание CSPLCD39G
