Commercial SmartPad LCD
¥
Page:
15
© 2006 Xantech Corporation
A
B
DETAIL A
Push Clip with thumb in direction
of arrow. Back of clip should move
down into SLOT B. If more pressure
is needed, use a screw driver as in
DETAIL B
TAB OF CLIP
SCREW DRIVER
Detail B
STEP 8
STEP 9
MOUNTING
CLIPS
WALL
BACK BOX
STEP 10
Figure 7 – Installing Back Box Mounting Clips
CSPLCD POWER SUPPLY AND INPUT/OUTPUT WIRING INSTRUCTIONS
The SmartPad LCD can be interfaced in numerous fashions; Standard Xantech IR Bus, RS232, Direct
Connect to CM8X8/MRC88, External IR Input, and Local IR (Emitter Output). The following sections below
address each of these wiring configurations.
P
OWER
S
UPPLY
& S
TANDARD
X
ANTECH
IR O
UTPUT
B
US
W
IRING
:
(Figure 3-19)
A 4-Termianl WECO connector is provided with the CSPLCD for the +16VDC, GND, STATUS, and IR OUT
connections. For convenience of wiring, it is recommended that the Power Supply and IR Connecting Block
be placed at the same location although this is not required. If placed in the same location, 4-Conductor
18AWG is recommended for ease of wiring.
Power Supply Wiring:
The SmartPad LCD series requires a 16VDC Power Supply (Xantech Model #SPLCDPS1).
This is a 16VDC Power Supply @ 1.5A and is sufficient for providing power for one CSPLCD unit.
Содержание CSPLCD39G
