Commercial SmartPad LCD
¥
Page:
67
© 2006 Xantech Corporation
Connecting the
CSPLCD to the
MRC88 Controller:
1. Connect one end of the CAT5 to the
Keypad
port on the rear of the MRC88
Controller and the other end to the
Controller
port on the rear of the CSPLCD
Panel.
2. 16Vdc Power must still be run directly to the +16VDC and GND Terminals on
the rear of the CSPLCD panel.
Note:
The CSPLCD cannot be powered directly from the MRC88 Controller.
3. If using multiple keypads in a single Zone, the last keypad in line must have
the Zone Termination Jumper installed.
Note:
The CSPLCD comes with the Zone Termination Jumper installed by default.
Configuring
Dragon Drop
CSPLCD for MRC88
Emulation Mode:
1. Program the MRC88 as you would for a standard MRC88 Keypad using both
the Tier1 and Tier2 of the buttons for added functionality.
2. Create the graphic layout for an CSPLCD project in Dragon as you would
normally.
3. After all of the GTL’s are layed out as in a standard CSPLCD project, click on
the TAB labeled
MRC88
in the CSPLCD Systems Window.
4. Check the box labeled
Emulate MRC88 Keypad
5. If you are using Multiple Keypads in a single zone, set each keypad to a
unique
Keypad Address
. Up to four keypads can be used together in a single
zone.
Note:
If using standard MRC88 Keypads in conjunction with the
CSPLCD in the Zone, you must set the MRC88KP Address Jumper to the
specific address.
6. Under
MRC88 Source Names
enter the names as they appear in the MRC88
Software.
Note:
This is necessary for proper Source Name display when
using the MRC88
STATUS
function.
Programming
CSPLCD for MRC88
Functionality:
Once Dragon Drop CSPLCD is configured for MRC88 Keypad Emulation, you can
now point each GTL on the SmartPad LCD™ to a specific macro within the MRC88
Controller.
1. Click on the MACROs Tab to lock in the current GTL button layout.
2. Select a Source Button in the CSPLCD Systems Window.
3. Click on the PALETTES menu and select
Internal Commands
from the drop-
down menu.
4. Click
on
Backlight Set
in the Internal Command Window and select MRC88
Button Id from the drop-down menu.
Name Each Source
as it appears in the
DragMRC Project.
Содержание CSPLCD39G
