X - R i t e e X a c t ™ I n s t r u m e n t
30
Pass/Fail Indication
Used to activate the pass/fail indication for comparison measurements. Options are: On and Off.
If activated, pass/fail is indicated in the upper right corner of the screen (near the view standard
icon).
Refer to Pass/Fail Measure procedure in the Compare Tool section for additional information.
Averaging
Used to set the number of measurements required to obtain an average. The number of reading
can be set from 2 to 5 and off.
Refer to Averaging Measure procedure in the Compare Tool section for additional information.
Function Settings
Function settings that appear depend on the Active Function selected for a particular tool. For
example, BestMatch will not appear as a selectable function setting if BestMatch is not selected as
an Active Function.
To edit a function setting, tap the function button and select the desired parameters.
Information on Function Settings can be found within each measurement function that follows.
Gray Balance Patch Setting (for Auto Patch Tool only):
Set up to three tint patch percentages for gray balance patch measurements. Typically, these
values are 25%, 50% and 75%, or 40% and 80%, however, you can also enter custom values.
These values are used to detect the patches with the Auto Patch Tool.
