Wood-mizer TVS-FT Series, Руководство пользователя, Страница: 70 / 116

ALIGNMENT
Blade Installation And Tracking
5
5-2 MHdoc031016
1. Turn the key switch to the "H" position.
2. Open the blade housing covers.
3. Manually spin one of the blade wheels until the blade positions itself on the wheels.
See Figure 5-2. The blade wheels should be adjusted so that the gullet of 1 1/4" blades
rides 3.0 mm (0.12") out from the front edge of the wheels (± 1.0 mm [0.04"]). The gullet
of 1 1/2" blades should ride 4
. 5 mm (0.18") from the front edge of the wheels (± 1.0 mm
[0.04"]). Do not let the teeth ride on the belt.
To adjust where the blade travels on the idle-side blade wheel, use the cant control
shown in
Figure 5-1 .
To move the blade out on the blade wheel, turn the cant adjustment bolt clockwise.
To move the blade in on the blade wheel, turn the bolt counterclockwise.
Some adjustment in blade tension may be needed to compensate for adjustments made
with the cant control.
Adjustment with the cant control is usually all that is required to track the blade properly
on both blade wheels. The drive-side blade wheel will usually not have to be adjusted.
If necessary, the drive-side wheel can be adjusted as follows:
Locate the adjusting bolt with lock nuts located on the drive-side of the cutting head.
Turn the bolt clockwise to move the blade out on the wheel, turn it counterclockwise to
FIG. 5-2
H
SM0044D
1 1/2"
Blade
± 1 mm (0.04”)
1 1/4"
Blade
3.0 mm (0.12”)
± 1 mm (0.04”)
4.5 mm (0.18”)