Wood-mizer TVS-FT Series, Руководство пользователя, Страница: 23 / 116

OPERATION
TVS Setup
Operation MHdoc031016 2-6
2
IMPORTANT! When starting the machine for the first time,
check that blade rotation direction is as indicated by the
arrow located on the blades covers. If the rotation direction
is incorrect, invert the phases in the phase inverter located
in the power socket (electric box). Setting the phases in the
phase inverter correctly will ensure correct rotation
directions of all machine motors (machines not equipped
with phase failure relay). If your machine is equipped with
phase failure relay, motors will not start until the phase are
not set properly.
IMPORTANT! When starting the machine for the first time,
let it run without any load for 1-2 hours. It will let the infeed
and outfeed tables drive components to grind in.
DANGER! It is recommended that a 30mA Ground Fault
Interrupter (GFI) be used.
11. Locate the air assembly at the left side of the machine. Connect the incoming air supply
line to the fitting. Make sure the air gauge indicates 0,6MPa (6bar) Adjust the pressure if
needed. To adjust the pressure, lift the black cap located behind the air gauge. Turn the
cap clockwise to increase pressure, turn the cap counterclockwise to decrease pressure.
Push the cap down to secure when adjustment is complete. Air supply cut-off valve
should be used to disconnect air supply and release compressed air from the pneumatic
system. Set the cut-off valve to “SUP.” position for normal operation or to “Exh.” to release
compressed air.
WARNING! Disconnect air supply and release compressed
air from the air system before servicing the saw! Failure to
do so may result in serious injury.
!
!