OPERATION
Cutting Width Setting
2
2-19
MHdoc031016
Operation
2.9
Cutting Width Setting
1.
Install a blade if needed and check for correct blade tension.
).
2.
If your TVS is equipped with the electric cutting width setting,
SETWORKS OPERATION (Optional Equipment)
.
3.
Set the saw heads at the desired width using the handle and width scale shown in the
figure below.
4.
Set the adjustable blade guide as close to the material as practicable so the blade guide
clears the material along the entire length.
See Figure 2-10.
To move the saw heads in, turn the handle left. To move saw heads out,
turn the handle right.
5.
If TVS is equipped with optional laser assembly, laser beam Indicates the cut position.
DANGER!
Visible and/or invisible laser radiation. Avoid eye
or skin exposure to direct or scattered radiation.
FIG. 2-10
Indicates
width
of material
to be cut
Содержание TVS-FT Series
Страница 1: ......
Страница 2: ......
Страница 25: ...OPERATION TVS Setup Operation MHdoc031016 2 8 2 infeed table FIG 2 3 TVS SAW HEAD FIG 2 3 OUTFEED TABLE...
Страница 26: ...OPERATION TVS Setup 2 2 9 MHdoc031016 Operation FIG 2 3 ADDITIONAL INFEED TABLE...