Page 41
Component Removal
Integrated Modules
Integrated Modules
3-9
#826498 - Revision B - December, 2016
Figure 3-13. Generator Assembly
Generator Assembly
To remove the generator assembly first remove the
generator plate, then (See Figure 3-13):
1.
Turn generator over and use T-20 Torx drive or
large flat blade screw driver to disconnect power
wire harness from generator assembly.
2.
Disconnect comm cable.
3.
Remove generator assembly.
Intake Gasket
To remove the intake gasket first remove the generator,
then (See Figure 3-14):
1.
Turn generator over and remove any remaining
pieces of old intake gasket.
2.
Attach new intake gasket.
Support Spring, Mounting Pin, and Washer
To remove the support spring, mounting pin or washer,
first remove the generator, then (See Figure 3-15):
1.
Remove support spring from mounting pin.
2.
Use a 7/16” open end wrench to remove the
mounting pin.
3.
Remove washer from clinch stud.
Figure 3-14. Intake Gasket
Figure 3-15. Support Spring, Mounting Pin, Washer
Generator
Intake Gasket
