Page 35
Component Removal
Integrated Modules
Integrated Modules
3-3
#826498 - Revision B - December, 2016
Figure 3-1. Glass Top Screws
Figure 3-2. Element Assemblies
Glass Top
To remove the glass top, first remove the cooktop from
its installation, then (See Figure 3-1):
1.
Use a Phillips screw driver or a 1/4” nut driver to
extract screws from front frame.
2.
Use a Phillips screw driver or a 1/4” nut driver to
extract screws from back frame.
3.
Remove glass top.
4.
Disconnect Low Voltage (LV) wire harness from
power board.
5.
Disconnect element wire harness from power
board.
Element Assembly
To remove the element assembly, first remove the glass
top, then (See Figure 3-2):
1.
Disconnect spade terminals from the element
assembly.
NOTE:
Make note of wire locations prior to removing
the spade terminals.
2.
Use a T-15 Torx driver to extract the screws that
hold the element springs.
2.
Remove the element springs.
3.
Use a T-15 Torx driver to extract the screw holding
the element bracket to the element assembly.
4.
Remove the element brackets.
5.
Remove the element assembly.
T-15 Screws
Element
Spring
Element
Bracket
Component Removal - CE152TF/S
