Will Burt 10-60 HDL, Руководство по эксплуатации

Страница: 126 / 166

PAGE 124 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
Figure 5-34 Relay and Magnetic Switch Assembly Wiring
10. Use customer-supplied 16 AWG stranded wire to connect the magnetic switch assembly to
vehicle power through the ignition.
11. Ensure:
a. The mast is fully nested.
b. The flasher and lights are installed and connected to the ignition through the battery.
c. The ignition is on.
Note: The light should be flashing unless the switch is in contact with the magnet assembly.
12. Slide the magnetic switch assembly up and down the lower two feet (60 cm) of the base tube
to locate the magnet assembly inside the tube. When the magnet assembly is located, the
lights will stop flashing. The vertical sensing range should be about 1 to 3 inches (2.5 to 7.5
cm).
13. Tighten the band to clamp the switch assembly within the sensing range ensuring it is not
lower than 1 inch (2.5 cm) above the lower limit of the sensing range. The 1 inch (2.5 cm)
allows for seasonal variations in the top tube position.
14. Attach the “NOTICE” label in a visible area on the base tube (Figure 5-33).
15. Attach the “MAGNETIC EXTENSION WARNING KIT” label to the magnetic switch assembly
(Figure 5-33).
16. Extend the mast 1 to 2 feet (31 to 61 cm) and then nest the mast. Repeat several times to
test the magnetic warning kit. For information on operating the mast system, see Section 6.3.
16 AWG to Flasher
16 AWG to Ignition Switch
16 AWG to Ground
Relay (Bottom View)
16 AWG
Magnetic Switch Feed Wires Through Grommet
Assembly
Magnetic Switch Wire Nuts