Will Burt 10-60 HDL, Руководство по эксплуатации

Страница: 88 / 166

PAGE 86 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
5.6.2.4 Position the Mast
To position the mast:
1. Carefully move the mast into the desired mounting location.
2. Lower the mast the rest of the way to the mounting surface.
3. Carefully move the mast into position ensuring the mast is level. It is necessary to check the
mast in two places 90° apart when leveling. Be certain to orient the mast so the operator has
a clear view of the hazard labels.
Note: Additional labels are provided with the operator’s manual and should be applied where
the operator will have a clear view of them while operating the masts.
5.6.2.5 Install the External Support Bracket
This section describes installation of the external support bracket for the Heavy Duty and Super
Heavy Duty masts. For information on how to install the external support bracket for the Ultra
Heavy Duty masts, skip ahead a few pages and find the section that says “Ultra Heavy Duty:
Install the External Support Bracket”.
To install the external support bracket:
1. Determine the desired location for the external support bracket. The external support bracket
must be at least 1 inch (25 mm) above the drain hole and at least 1 inch (25 mm) below the
base tube collar. Do not cover the drain hole. The exact dimensions of the mast system will
vary based on the components included. Refer to Section 4.5.5 for dimension information.