Will Burt 10-60 HDL, Руководство по эксплуатации

Страница: 108 / 166

PAGE 106 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
Rotatable Super Heavy Duty Masts
This section describes installing the flashing kit. If retrofitting a mast to use a flashing kit, see
Installing the Internal Mount Flashing Kit
(TP-5351001). To obtain this document, contact The
Will-Burt Company.
To complete installation:
1. With the paper on the tape, position the flashing halves around the mast. Allow the flashing
halves to rest on the internal mount.
2. Raise the flashing halves ⅛ inch (3 mm).
3. Ensure there will be no obstructions with the sealant or roof line when the mast rotates and
mark the top of the flashing halves with a pencil.
4. Remove the paper from the tape, and position the flashing halves so they align with the pencil
mark.
5. Secure the flashing kit tight to the mast with:
a. (6) ¼-20x0.75 Inch Bolts (P/N: 4542)
b. (12) ¼ Flat Washers (P/N: 0800)
c. (6) Nyloc Nuts (P/N: 1930)
Do not overtighten the flashing kit because tightening too much can deform the base tube
and impede the movement of the next internal section.
6. Inspect the seal and add any tape if required.