Will Burt 10-60 HDL, Руководство по эксплуатации

Страница: 103 / 166

PAGE 101 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
For Super Heavy Duty and Ultra Heavy Duty masts:
a. Line up the holes in the roof, gasket, and roof ring (Figure 5-16). Ensure the gasket is
between the roof and roof ring. Leave the retaining ring and o-ring off. These will be
installed later.
For non-rotatable mast systems, leave the retaining ring and o-ring off. These will be
installed later.
For rotatable mast systems, line up the holes in the retaining ring. Rotatable mast systems
will have flashing kit instead of an o-ring. The flashing kit will be installed later.
b. Replace any roof liner or ceiling panel.
c. Fit the other gasket (Figure 5-14 and Figure 5-16) against the inside of the roof. This
gasket does not need sealant. It will be held in place by the ceiling plate. Fit the ceiling
plate in place and ensure all holes align.
d. For non-rotatable mast systems, temporarily secure this assembly together. Do not torque
hardware. Hardware will be torqued during final assembly.
For rotatable mast systems, fasten the assembly (Figure 5-18) together using:
i. (8) ¼ inch (M6) Bolts
ii. (8) ¼ inch (M6) Lock Washers
iii. (8) ¼ Inch (M6) Nuts
Figure 5-18 Fasten Assembly Together
The mounting hardware must include proper means to resist vibration loosening such as
thread-locking compound or locking hardware. Torque all hardware as appropriate for its size
and grade.
d. Clean off any silicone sealant that may have squeezed out into the hole cut for the mast.
Retaining Ring
Roof Ring
Roof
Ceiling Plate
Lock Washer
¼ inch Bolt
Gasket
Nut