Will Burt 10-60 HDL, Руководство по эксплуатации

Страница: 112 / 166

PAGE 110 OF 164
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
TP-5580101-A
FEBRUARY 2022
3. Attach the brass cross to the desired air inlet port with a close Nipple, ⅜ x ¼ bushing, and ½ x
⅜ bushing (Figure 5-20). Apply PTFE Tape to all threaded joints. If necessary, air hose may
be used to connect between the air inlet port and the brass cross, however, the brass cross
should be installed as close to the mast as possible to ensure proper drainage.
Figure 5-20 Pneumatic System Installation
4. Attach the safety valve to the brass cross. Apply PTFE Tape to all threaded joints.
5. Attach the drain cock to the brass cross. Apply PTFE Tape to all threaded joints.
Note: The drain cock should be located at the lowest point. When the mast is not in use, or when
a locking mast is deployed and depressurized, the drain cock shall be left open. If the drain cock
is not left open when not in use, it can collect condensation and fill up with water. This water can
freeze, which causes the mast to not function correctly or break.
½ x ⅜ Bushing
Safety Valve
Brass Cross
Close Nipple
⅜ x ¼ Bushing
Drain Cock
Close Nipple