Wfly ET Series, Инструкция по эксплуатации

Страница: 64 / 131

Slave Aileron
Program mixes
Status
Switch
Master
INH
- -
Link
OFF
OFF
Trim
OFF Throttle
1/2
Slave Aileron
Program mixes
Status
Switch
Master
INH
- -
Link
OFF
OFF
Trim
OFF Throttle
Rate+
Rate-
0
%
0 % 偏置 0 %
1/2
Program Mixes
Interface path: WFLY → [General Menu] → [Program Mixes]
It can create 10 mixing combinations, which can be customized by selecting channels or switch knobs,
and supports mixing of 3 curve types (EX1, EXP2, and polyline). In addition to being used to create a
variety of aircraft flight characteristics, it can be used for a variety of other purposes.
The direction of the mixing ratio can be set separately.
Ratio mode: Ratio mixing for simple mixing with directional settings.
Curve mode: Curve mixing, precise control of mixing between different strokes, where “polyline” can be
precisely adjusted using 5, 7, and 13 points.
Program mixes 2/2
+150
+100
+50
0
-50
-100
-150
+0% RATE +0% POS
Offset
Type
0% EXP1
Rate B Rate A
+100% +100%
EXP B EXP A
100% 100%
Program mixes
5
4
3
2
1
Throttle to Aileron
Throttle to Aileron
Mixing
INH
INH
INH
Curve
Offset
Mode
Offset
Offset
Offset
1/2
Ratio mixes
Curve
mixes
Slave
Status
Switch
Master
0%
0%
0%
H/W/Switch/Knob
Channel
Select
Close
?
Program mixes
Control
Switch
The setting of the ratio programming mixes
(refer to the above mixing 1):
1 Switch the mode to the ratio and click on the
name of the mixed control 1 (the mixed control name
is the name generated by the combination of the
primary and secondary channels, such as the view
from the throttle to the aileron), and enter the mixing
configuration interface.
2 To use this programming mixes, you need to
enable this feature, so the status needs to be
switched to enabled. (When inhibit, the control
switch cannot be activated when it hits the active
position.)
3 Set the control switch, the default is [--], we can
set it as switch, knob rocker and so on.
4 Assign the primary and secondary channels,
and confirm the channel polarity by actual
operation.
5 Set the mixing ratio. There are two ratios of
positive and negative, which can control the mixing
ratio in both directions.
6 Set the offset ratio, which is used to set the up
and down offset of the midpoint of the overall mixing
position relationship.
The setting of the curve programming mixing
control (refer to the above mixing control 2):
1 Switch the mode to the curve;
Status, Switch, Channel Assignment Reference
"Settings for Ratio Programming Mix" (Step 234
described on the left)
5 Curve setting, here you can select three curves
for more precise adjustment.
064
General Menu