Wfly ET Series, Инструкция по эксплуатации

Страница: 102 / 131

V-Tail
Interface path: WFLY → [Model Menu] → [V-Tail]
If the tail type is "V-tail" which is selected from the model type selection of the context menu, the elevator
and rudder of the V-tail can be adjusted in this interface. (The V-tail uses two servos to control the rudder at
the same time. It is used as an elevator. In addition to the simultaneous lifting and lowering of each rudder
surface (used as an elevator), the two rudder surfaces are used as rudders in the opposite direction. For
the V-tail,This is also known as the direction elevator because they can be used for both the rudder and the
elevator.)
Elevator
(Rudder2)
Rudder
(Elevator2)
V-Tail
ELE
RUD2
RUD
ELE2
Down Up
+50%
+50%
+50%
+50%
ELE
Left Right
+50%
+50%
+50%
+50%
RUD
Adjust the amount
of the elevator Adjust the amount of
the rudder
Range ±120%;Default 50%
● The amount of operation of each servo can be adjusted separately. (For the connection method
of the servo, please refer to "Servo connection of different model categories")
● When the connection causes the mixing direction to be reversed, it can be adjusted by
changing the polarity (+/-) of the action amount.
● When the amount of action is too large or the rudder is repeated, the servor may not respond.
Please adjust before and after 50%. Be sure to confirm the actual movement of the body when
setting.
* Flight conditions: Set the "Flight Condition" control switch in [Model Menu] → [Condition].
Switching is performed by switches, and function settings are made separately.
Action output example:
102
Model Menu\Airplane