Merrychef eikon
®
e2s service and repair manual
71
_______________________________________________________________________________________________________________________________
_______________________________________________________________________________________________________________________________
6 Replacing components
Back to contents >
6.4
Removing / fitting the door assembly
Component
Tools required
Two metal pins, 3mm diameter & 10mm long (if the door hinges are to be removed / replaced)
Two metal pins, 2 to 3mm diameter & 40mm or longer in length (if the door hinges do not require removal)
M5.5 hex socket wrench
M8 hex socket wrench
Torque wrench
PZ1 Pozidriv screwdriver
M3 hex key socket
Removing components of the door assembly
Requirements
Check that the following requirements have been met:
§
The appliance has been disconnected from the power supply and
protective measures have been taken to ensure the power cannot be
switched on again.
§
The appliance is cool.
§
Additional PPE, Mask & Gloves for handling insulation material
2.
Fully open the oven
door. Insert the metal pins
into the corresponding
holes each door hinge, as
marked up in the image, to
lock the door hinge. Ensure
the pins remain in this
position until the door is
refitted to the oven again.
3.
Tilt the oven door
up to an angle of
approx. 30° from
horizontal.
4.
Remove the door
assembly from the
oven performing a
rotational movement
of lifting the door up
and pulling it away
from the casing.
Do not use excessive
force.
5.
Unfasten the two bottom
M5.5 hex head flange bolts next
to the door hinges to remove
the cover panel from the door
frame.
1.
Remove the
locking screw and
tab from both sides.
