Merrychef eikon
®
e2s service and repair manual
108
_______________________________________________________________________________________________________________________________
_______________________________________________________________________________________________________________________________
8 Annual PM check
Back to contents >
8 Annual PM check procedure for eikon
®
e2s
Task(s):
Annual Technician PM check
Frequency:
Annual
Time to complete:
1-3 hours
Model(s):
Merrychef eikon® e2s
Service procedures
•
All tests to be carried out by a trained Merrychef technician.
•
Ensure all documented safety procedures are followed for each individual task.
•
Refer to the relevant section within this manual for task details.
Task A
Safety information:
Please adhere to all
Merrychef safety aspects
at all times.
Electricity
Manual handling
Hot liquids
1.
Check the oven for
obvious signs of damage
and cleanliness. Switch the
oven on and off with front
switch, allow to cool down.
2.
Check the power cord
and plug for damage and
replace if required.
3.
Remove the air filter and
check for damage, clean
and insert or replace if
required.
4.1.
Pre-Jan 2019
Remove old cook plate verify
the PTFE feet are intact if not
replace with new (angled
edge at the front of the
cavity).
4.2.
Post Jan 2019
Remove old cook plate and
inspect the scallops
(recessed area) for arcing
and carbonisation. Replace
if worn.
5.
Inspect the 4 studs for
signs of carbon and
arching, Remove the side
panels and replace as
required.
6.
Check the door seal,
ensuring that it is intact,
not hanging loose or have
any sections broken away
or cracked. Replace if
required and allow silicone
to cure.
7.
Remove & refit upper
impinger plate inspecting for
cleanliness and signs of
damage (if required follow
the instructions laid out in the
replacement impinger Kit).
Visually check the partition
plate for signs of
discolouration or damage.
