WaterLogic WL Cube, Руководство по эксплуатации, установке и обслуживанию

Страница: 21 / 76

13. Securely tighten the filter body to the filter head.
14. Fit the filter assembly with the sanitation fluid into the machine:
Insert the filter assembly back into its cradle, aligning the two male
spigots with the female holes in the cradle
Push it firmly until the filter sits snugly and is flush with the cradle
top surface
Lock the filter by closing the locking lever until it ‘clicks’ into place.
15. Reinstall the top cover and insert the two screws at the rear of the
machine that secure it.
16. Reconnect the power lead and insert it into the rear of
the machine. Turn on the Red Power Switch I=ON
17. Turn on the water supply at the isolation point
18. Place a container under the dispense area and dispense 2 cups of cold
water and then 1 cup of ambient water.
While you are dispensing the cold water hold a chlorine test strip under
the dispense area and test the flow of water to check that the sanitation
fluid is present in the cold tank.
CUBE Operating, Installation, and Service Manual Page 21 - Revision: 6-23-2015