WaterLogic WL Cube, Руководство по эксплуатации, установке и обслуживанию

Страница: 18 / 76

10. Select the Cold Button and the Dispense Button to allow water to flow until water is clear.
11. Turn on the Green Heater / Compressor switch for approximately an
hour for the Cube to heat and chill. I=ON
12. Test water temperatures and ensure the water tastes acceptable.
13. Verify all functions of the Cube work correctly.
14. Turn off the Red Power Switch and the Green Heater/Compressor
Switch. O=OFF
15. Turn off the water.
16. Drain from rear drain valves.
17. Clean and repack for installation.
Flush Filters
CAUTION! FILTER FLUSH REQUIRED.
The Cube is supplied with a filter
. Filters should be configured to optimize your system. Filters need
to be configured and specified to do the job given the local water conditions, usage, maintenance
schedule, and placement restrictions.
In order for our filters to perform as represented and to provide the best quality water possible, it is
essential that filters be replaced periodically. The frequency of filter changes depends upon your
water quality and your water usage. For example, if there is a lot of sediment and/or particles in
your water, then you will have to change your filters more frequently than a location with little to no
sediment. Be sure to replace your filters whenever you notice a decline in the performance, whether
it is a drop in flow rate and/or pressure or an unusual taste in the water.
1. Select Ambient Water Sel Dispensing Button. Dispense approximately 10 liters of water to
remove the excess carbon fines and generate the filter.
NOTE: Filters should not be flushed prior to 24 hours before installation to limit Microbial Growth.
CUBE Operating, Installation, and Service Manual Page 18 - Revision: 6-23-2015