WaterLogic WL Cube, Руководство по эксплуатации, установке и обслуживанию

Страница: 30 / 76

6. Use a Phillips-head screwdriver to remove the two screws at
the rear of the machine that hold the top panel in place
7. Remove the top panel by placing your hands on the top as
shown in the picture and push it backwards and then lift it up to
remove.
8. Replace the carbon block filter. Insert your finger into the top
of the carbon block filter (the filter that is closer to the front of
the machine) and pull the lever up to the vertical position.
9. Pull the lever straight up to remove the filter assembly (some
slight force may be required)
10. Unscrew the filter body from the filter head by turning the base
in an anti-clockwise direction.
11. Remove the filter cartridge from the filter head by pulling it out
as shown.
12. Add the required amount of sanitation fluid to the empty filter
housing.
13. Securely tighten the filter body to the filter head.
CUBE Operating, Installation, and Service Manual Page 30 - Revision: 6-23-2015