4 Safety
11
100_0102_si_0003.fm
Train staff at regular intervals and inform them about potential hazards.
Provide staff with the required protective gear.
4.6
Personnel qualification
This machine may only be operated and used by trained staff.
Incorrect application, misuse or use by untrained staff threaten the health of the users and/or third parties
and risk damaging the machine or causing a failure.
The following requirements also apply to the user:
Physically and mentally fit.
Reactions not impeded by drugs, alcohol or medication.
Familiarity with the safety information in this manual.
Familiarity with correct operation of this machine.
The minimum age to use the machine has been reached.
Instructed in how to operate the machine independently.
4.7
Residual dangers
The following section lists dangers based on the risk assessment. Residual risks are particular risks
associated with handling machinery which, despite compliance with the standards of safe construction,
cannot be eliminated.
Residual risks are not obviously recognizable and can be the source of a potential injury or risk to health.
If unforeseeable residual risks occur, the machine must be switched off immediately and the
competent manager informed. The manager will make further decisions and do everything necessary
to eliminate the risk.
The manufacturer of the machine must be informed if necessary.
DANGER
Risk of fatal injury from electrical voltage!
There is an immediate danger to life from touching live parts. Damaged insulation or
individual parts can be dangerous to life.
Therefore:
If the insulation is damaged, immediately disconnect the power supply and arrange
repair work.
Only allow qualified electricians to perform work on the electrical system.
The electrical system must be disconnected from the mains power and tested to
ensure no voltage.
The power supply must be switched off before maintenance, cleaning and repair work
and fused before being switched on again.
Do not bypass fuses or decommission. Use the correct number of amps when
changing fuses.
Protect live parts from wet conditions. Danger due to short circuit.
WARNING
Noise-induced hearing damage!
Noise in the area where work is performed can cause serious hearing damage.
Therefore:
Suitable ear protection must be worn during all work that generates noise.
Only remain in the danger zone for as long as is necessary.
WARNING
Heat-induced risk of burning!
The machine can become extremely hot during long use and cause burns on contact with
skin. Therefore:
Allow the machine to cool down after use.
If the cooling down stage cannot be complied with (e.g. in an emergency), always wear
heat-resistant gloves.
