W & H Lisa, Инструкция по эксплуатации

Страница: 13 / 78

9
4.2 ELECTRICAL POWER SUPPLY
The electrical power supply of the sterilizer must comply with all applicable standards in the country of use.
The following characteristics are required:
- Single - phase 200 - 240 VAC ±10%, 50/60 Hz, 10 A, on a
dedicated circuit
.
- Installation category / mains overload category =
II
- 10 A differential circuit breaker with a sensitivity of 30 mA.
The circuit breaker must be a certified type according to ap-
plicable norms.
- Maximum power consumption of the sterilizer is 2,000 -
2,400W (10 A)
- A grounded connection is essential.
Check that the voltage specified on the name plate located on the backside of the
sterilizer corresponds to the supplied mains voltage.
The overall electrical safety of the sterilizer is guaranteed only if the mains voltage
supply is properly grounded according to all applicable norms.
If unclear, have the electrical installation checked by a qualified electrician.
Do not plug other equipment into the same socket/circuit .
Do not bend or twist the mains cable.
Only use the original mains cable as supplied with the sterilizer.
Do not use cable extensions.
4.3 PRINTER (optional)
We recommend the use of LisaPrint (conforms to the IEC 61010-1 norm) as it has
been tested for compatibility with the sterilizer and its software.
The use of printers other than the ones listed in the relevant printer setup menu (see
6.1.3) clears the manufacturer of any responsibility for warranty or any other claims.
-
Connect the printer cable to the 25-pin parallel port socket at the back
of the sterilizer. Cable length should not exceed 2 meters.
-
Connect the printer mains cable.
-
Switch ON the printer.
- Select the printer type (§ 6.1.3). LisaPrint is the default setting
(Print-p).
All necessary data to document sterilization cycles is automatically printed
(for details see Appendix 8).
NOTE: Lisa 517/522 sterilizers offer the option to digitally save cycle data on removable memo-
ry cards.