Installation Guide
Chapter 2. Setting Up Your System
2.10
6.
To attach the camera assembly to the monitor bracket, first engage the front
stud into the V-slot of the camera bracket.
7.
Next, slide the Camera bracket forward until the two threaded studs at the rear
of the plates engage the clearance holes in the bracket.
8.
Use the two knurled nuts to secure the mounting bracket to the camera
assembly. Tighten until snug, being careful not to overtighten.
5. Mounting the PC and remote devices receiver
If you do not have a cart, position the PC on a sturdy surface within two feet of the
monitor. Place the IR Receiver (found in the VTEL PC box) nearby, or on top of the
monitor. The IR Receiver has an adhesive strip that can be used to secure the device to
the desired location. Be sure that the receiver is not obstructed in any way.
If you have purchased the optional SmartCart, the PC will already be secured to the cart
with the metal tie-down strap. Should you need to remove the strap at any time, press
the bottom of each side lever downward (step 1) to release the tightening mechanism
(2). To re-attach the strap, press each side lever upward to engage the tightening
mechanism.
Next, secure the IR Receiver to the top shelf of the cart, or to the top of the monitor.
The IR Receiver has an adhesive strip which can be used to secure the device to the cart.
Содержание WG500
