19
There are three main steps to installing the TruckWeigh® system:
• Junction box installation. This must be installed on the chassis of the vehicle. It must be located in
an appropriate position between the suspension systems and the cab of the vehicle. The internal
domain cable must be routed to each sensor position.
• Sensor installation. The type of sensors you install will depend on the suspension systems in
operation on the vehicle. Air pressure transducers are installed on air suspension systems. Axle
transducers are installed on steel axle suspension systems. The sensors must be installed in an
appropriate position on the suspension system and linked to the junction box with the internal
domain cables.
• Install the display unit. The display unit must be installed in the cab of the vehicle. It must be linked
to the junction box with the external domain cable and connected to the vehicles power supply. See
“How to install the display unit” on page 37.
It is recommended that the junction box is installed first, followed by the sensors and the display
unit. However, these steps can be performed in any order.
TruckWeigh
®
TruckWeigh®
Содержание TruckWeigh
