VPG TruckWeigh, Руководство по установке, настройке и калибровке

Страница: 78 / 130

78
• Air group. This is used to indicate that air transducers are located on the axle. All axles which use
the same air pressure transducers must be configured as part of the same group. There are three
options:
• Air group front. This is used to indicate the first axle in an air group. If a single air sensor is
used for the whole group, the number of sensors is 1. If a single sensor is used to measure
the left side of the group and a single sensor used to measure the right side, the number of
sensors is 2.
• Air group centre. This is used to indicate any axle between the front and rear axle of the air
group. The number of sensors is always the same as the number of sensors on the Air group
front axle.
• Air group rear. This is used to indicate the last axle in the air group. The number of sensors is
always the same as the number of sensors on the axle at the front of the air group.
Multiple air groups should not be combined into one group. For example, if an air group is located
on axle 2 and 3, and a second air group is located on axle 4, 5 and 6. In this case, axle 2 is an air
group front and axle 3 is an air group rear. Axle 4 is an air group front, axle 5 is an air group middle
and axle 6 is an air group rear.
A G
A G
A G
A G
2: Type: Air Group Front
3: Type: Air Group Centre
4: Type: Air Group Rear
Axle Config.
Sensors: 1
Sensors: 1
Sensors: 1
TruckWeigh
®