44
Switches Operation
Position 1 – On position 1, the swithes will be OFF;
Position 2 – On position 2, the switches will be partially activated, that is, in this
stage the functions will be restricted to one of the phases;
Position 3 – On position 3, the switches will be fully activated, that is, the functions
connected to these switches will be fully operative.
Position 1
Switched off
Position 2
1st Stage
Position 3
2nd Stage
INTERRUPTERS
Alert Flickering Light Interruptor
Pressing the alert flickering button, all the side blinkers of the vehicle
start glowing, and to switch it off, press again.
IMPORTANT: This interruptor should be used only when the
vehicle is stopped, in emergency situations.
Signal Lights and Headlights Interrupter
The headlights and signal lights interruptor has three positions:
a) Headlights and signal lights are switched off;
b) Panel instruments lights and rear signal lights start glowing;
c) Low-beam headlights start glowing.
NOTE: The internal lightening of the switches, due to the LEDs, turns on
when the contact and starting switch is set in position 2.
Fog Lamps Interrupter
The fog-lamp interrupter has two positions:
a) Up – switched off;
b) Pressing down, the fog lamps start glowing.
Engine Brake
The engine brake activation is indicated for prolonged braking on long
slopes and for slowingdown in normal motion. The lower is the pass
of gearing, the more is the engine brake efficiency.
The proper use of the engine brake does not cause damages to the engine and
prolongs operating life of the brake system components. On long slopes, the
