16
5.
Basic Settings
5.1.
General Settings
5.1.1.
System
5.1.1.1.
Introduction
Management VLAN
To specify a VLAN group which can access the Switch.
The valid VLAN range is from 1 to 4094.
If you want to configure a management VLAN, the management VLAN should be
created first and the management VLAN should have at least one member port.
Host Name
The
hostname
is same as the SNMP system name. Its length is up to 64 characters.
The first 16 characters of the hostname will be configured as the CLI prompt.
Default Settings
The default Hostname is L2SWITCH
The default DHCP client is disabled.
The default Static IP is 192.168.0.254
Subnet Mask is 255.255.255.0
Default Gateway is 0.0.0.0
Management VLAN is 1.
5.1.1.2.
CLI Configuration
Node
Command
Description
enable
ping IPADDR [–c
COUNT]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4.
enable
ping IPADDR [–s SIZE]
This command sends an echo request to the
destination host. The –s parameter allow user to
specific the packet size. Valid range: 0 ~ 1047 bytes.
enable
ping IPADDR [–c
COUNT –s SIZE]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4. The
–s parameter allow user to specific the packet size.
Valid range: 0 ~ 1047 bytes.
enable
ping IPADDR [-s SIZE –c
COUNT]
This command sends an echo request to the
destination host. The –c parameter allow user to
specific the packet count. The default count is 4. The
–s parameter allow user to specific the packet size.
Valid range: 0 ~ 1047 bytes.
configure reboot
This command reboots the system.
configure hostname STRINGS
This command sets the system's network name.
configure interface eth0
This command enters the eth0 interface node to
configure the system IP.
