128
Week
Select a week day that you want to configure the schedule.
Check
Enables or Disables the PoE schedule on the specific port for a defined
time period.
Time (Hour)
6.11.3.
PD Alive Check
6.11.3.1.
Introduction
The function has a global
state
configuration. If the global state configuration is enabled. The
Switch will check the configurations of every port.
If the port’s
state
is enabled, the Switch will send keep-a-live probe packet every
interval
time.
If the host cannot respond when the keep-a-live probe packet count is over the
retry times
, the
Switch performs the
action, reboot/alarm/all
to the Power Device
,
depending on the port’s
configuration.
Power OFF Time (sec):
When PD has been rebooted, the PoE port restored power after the specified time.
Default:15, range: 3-120 sec.
Start up Time (sec):
When PD has been start up, the Switch will wait Start up time to do PoE Auto Checking.
Default: 60, range: 30-600 sec.
Interval Time (sec):
Device will send checking message to PD each interval time.
Default: 30, range: 10-120 sec.
Action:
The action when the failure detection.
All: S
end an alarm message to inform the administrator and then reboot the PD.
Alarm
: Just send an alarm message to inform the administrator.
None
: Keep Ping the remote PD but does nothing further.
Reboot
: Cut off the power of the PoE port, make PD rebooted.
6.11.3.2.
CLI Configuration
Node
Command
Description
enable
show pd-alive
This command displays the configuration of the PD
Alive Check.
configure pd-alive (disable|enable) This command disables or enables the global PD
Alive Check for the Switch.
Interface
pd-alive action
(reboot|alarm|all|none)
This command configures the action when the system
detects that the host cannot respond the keep-a-live
