8
Dismounting the switch
Pull out the lower edge of the switch and then remove the switch from the DIN rail.
3.2.3.
Wall mount Installation
Location:
The AW-IHT-1270 can be placed on a horizontal surface through wall-mounted kit
Place the switch by using mounting holes on the wall at the appropriate place
3.2.4.
Wiring Redundant Power Inputs
You can use “Terminal Block (PWR)” for Primary Power input and “Terminal Block (RPS)” for
secondary power source for Redundant Power Input.
To insert power wire and connect the 48~57V DC (or 24~57V DC for AW-IHT-1270-24V) power
to the power terminal block, follow the steps below:
✓
Use -at-head screw driver to loosen the wire-clamp screws.
✓
Insert the corresponding wires into contacts.
✓
Tighten the wire-clamp screws to prevent the wires from loosening.
Top view of Terminal Block is shown as picture:
3.2.5.
Powering On the Unit
