112
Port State
The port state of the LACP member port.
6.8.
Link Layer Discovery Protocol (LLDP)
6.8.1.
Introduction
The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations attached to
an IEEE 802® LAN to advertise, to other stations attached to the same IEEE 802 LAN, the major
capabilities provided by the system incorporating that station, the management address or
addresses of the entity or entities that provide management of those capabilities, and the
identification of the station’s point of attachment to the IEEE 802 LAN required by those
management entity or entities.
The information distributed via this protocol is stored by its recipients in a standard Management
Information Base (MIB), making it possible for the information to be accessed by a Network
Management System (NMS) using a management protocol such as the Simple Network
Management Protocol (SNMP).
Default Settings
The LLDP on the Switch is disabled.
Tx Interval : 30 seconds.
Tx Hold : 4 times.
Time To Live : 120 seconds.
Port Status Port Status
---- ------- ---- -------
1 Enable 2 Enable
3 Enable 4 Enable
5 Enable 6 Enable
7 Enable 8 Enable
9 Enable 10 Enable
11 Enable 12 Enable
6.8.2.
CLI Configuration
Node
Command
Description
enable
show lldp
This command displays the LLDP configurations.
enable
show lldp neighbor
This command displays all of the ports’ neighbor
information.
configure
lldp (disable|enable) This command globally enables / disables the LLDP
function on the Switch.
configure
lldp tx-interval
This command configures the interval to transmit the
LLDP packets.
configure
lldp tx-hold
This command configures the tx-hold time which
