92
index <1-6>
port.
qinq
active
This command enables the selective Q-in-Q
profile.
qinq
inactive
This command disables the selective Q-in-Q
profile.
qinq
cvid VLANID
This command specifies the customer’s VLAN
range on the incoming packets.
qinq
spvid VLANID
This command sets the service provider’s VLAN
ID for outgoing packets in selective Q-in-Q.
qinq
priority <0-7>
This command sets priority in selective Q-in-Q.
qinq
access-ports PORTLISTS
This command specifies the access ports to apply
the rule.
qinq
tunnel-ports PORTLISTS
This command specifies the tunnel ports to apply
the rule.
qinq
end
The command exits the CLI Q-in-Q node and
enters the CLI enable node.
qinq
exit
The command exits the CLI Q-in-Q node and
enter the CLI configure node.
qinq
show
The command shows the current selective Q-in-Q
profile configurations.
configure interface range
gigabitethernet1/0/
PORTLISTS
This command enters the interface configure
node.
if-range
vlan-stacking port-based
priority <0~7>
This command sets the priority in port based Q-in-
Q.
if-range
vlan-stacking port-based
role (tunnel|access|normal)
This command sets VLAN stacking port role.
if-range
vlan-stacking port-based
spvid <1~4096>
This command sets the service provider’s VID of
the specified port.
if-range
vlan-stacking tunnel-tpid
index <1-6>
This command sets TPID for a Q-in-Q tunnel
port.
