User Manual rev. 1.2. Aug. 2015
209
4-5 Security
4-5.1 Network
4-5.1.1 Port Security
4-5.1.1.1 Switch
This section shows the Port Security status. Port Security is a module with no direct
configuration. Configuration comes indirectly from other modules - the user modules. When a
user module has enabled port security on a port, the port is set-up for software-based learning.
In this mode, frames from unknown MAC addresses are passed on to the port security module,
which in turn asks all user modules whether to allow this new MAC address to forward or block
it. For a MAC address to be set in the forwarding state, all enabled user modules must
unanimously agree on allowing the MAC address to forward. If only one chooses to block it, it
will be blocked until that user module decides otherwise. The status page is divided into two
sections - one with a legend of user modules and one with the actual port status.
Web Interface
To configure a Port Security Switch Status Configuration in the web interface:
1.
Click Security, Network, Port Security,then Switch
2.
Checked “Auto-refresh”.
3.
Click “ Refresh“ to refresh the port detailed statistics.
Figure 4-5.1.1.1: The Port Security Switch Status
.
Содержание AW-GEV-264A Series
