Vitl Co-mix, Инструкция по эксплуатации

Страница: 45 / 51

Instructions for Use
45
9 Troubleshooting
For technical enquiries, please contact your distributor or ITL at the address
given on page 2 of this manual.
Table 17: Troubleshooting Tips
Unit Will Not Turn On
No power → Check power is switched on at wall outlet socket and rear of unit

5
Bad connection → Ensure power connector fully inserted into rear of unit  5
Unit fuse blown → Consult a qualified engineer  8.1
Unit Spuriously Resets or Restarts Automatically
Power connecter loose → Ensure connecter fully inserted at rear of unit

5
Supply brown-outs or black-outs → Power unit from a stable AC mains supply  11
Mixer Not Gripping Plate
Plate holder rubber pads dirty or worn → Inspect and clean pads  8.2
Mixer Will Not Run at Required Speed...
Unstable working surface → Ensure installed on solid, stable, level working surface  5
Load too heavy → Obverse mixing restrictions listed in Table 7 and Table 8

6.3
Mixing Ineffective or Not As Expected
Mixing speed too slow → Increase mixing speed for optimum performance  6.3.1
Mixing time too short → Increase mixing time to ensure adequate mixing  6.3.1
Lid wetting or sample leakage → Reduce mixing speed or fill volume

6.3
Vortexer Does Not Operate When Pad Is Depressed
Vortexing program not loaded → Select and load appropriate vortexing program

6.4
Vortexer auto-start mode not enabled → Set vortexing mode to Auto or Restart  7.4.5
Vortexer pad worn or deformed → Replace vortexing pad  8.2
Vortexing Fails to Re-suspend Solutions
Vortexing speed too slow → Increase vortexing speed for optimum performance

6.4.1
Vortexing time too short → Increase vortexing time  6.4.1
Vortexer pad slippery or worn → Clean or replace vortexer pad  8.2
Insufficient contact pressure between tube and vortexer pad → Use Restart mode

6.4.2
Unsuitable tube type or shape → Refer to Table 9 for suggested tube types  6.4
Vortexer Stops Unexpectedly When Running
Insufficient contact pressure between tube and vortexer pad → Use Restart mode  6.4.2
Inappropriate tube type being used → Refer to Table 9 for suggested tube types

6.4
Vortexer Starts Without Pad Being Depressed
Vortexer pad worn or deformed → Replace vortexing pad or use Manual mode  7.4.5