Vitek VT-3407 BK, Инструкция по эксплуатации, Страница: 5 / 28

5
ENGLISH
–
To avoid damaging the blades, do not pro-
cess too solid products such as cereals,
rice, spices, coffee beans, cheese, frozen
products.
–
When you use the blender attachment and
the products are hard to chop, add some
water, if it is possible.
USING THE WHISK
Use the whisk attachment (10) only to beat
cream, make biscuit dough or for mixing ready
desserts.
WARNING: Before assembling make sure
that the power plug is not inserted into the
mains socket.
• Insert the whisk (10) into the gear (9).
•
Insert the whisk gear (9) into the motor unit
(2), and turn it counterclockwise until bump-
ing.
• Insert the power plug into the mains socket.
• Put the whisk (10) into the bowl with products.
•
Set the required operation speed using the
control knob (5).
•
To switch the blender on, press and hold the
button (4). Use this operation mode for mixing
liquid products.
• If you press and hold the button (3), the unit
will operate at maximum rotation speed.
• After you finish using the unit, take the power
plug out of the socket, disconnect the whisk
(10) from the gear (9) and disconnect the
gear (9) from the motor unit (2) turning it
clockwise.
Attention!
–
Do not use the whisk (10) to make tight
dough.
–
Products should be put into the bowl
before the unit is switched on.
USING THE MINI CHOPPER
The chopper is used to chop meat, cheese,
onion, herbs, walnuts, almond, vegetables and
fruit.
Attention!
Do not chop very solid products, such as nut-
megs, coffee beans, cereals and ice.
Before you start chopping
–
Cut meat, cheese, onion, vegetables and fruit
into cubes approximately 2x2 cm in size.
–
Remove stems of herbs, peel the nuts.
–
Remove bones, sinews and cartilage from
meat.
–
To achieve the best results refer to the table
below.
Product type Weight, g.
Approximate
cooking time,
seconds
Onion (cut
into several
pieces)
60
4-8
Soft fruit 100 10
Garlic 50 4-8
Bread
(dried toast)
15 12
Cheese 30 12
Nuts 30 12
Eggs 80 8
Meat 80 8-12
Chopping
Caution: the knife is very sharp! Always hold
the knife by the upper plastic end.
• Place the chopper bowl (6) on a flat stable
surface.
• Set the chopping knife (7) on the axis of chop-
per bowl (6).
• Put the products into the chopper bowl (6).
Note:
–
Do not switch the unit on when the chopper
bowl (6) is empty.
–
Put the lid (8) on the chopper bowl (6).
–
Install the motor unit (2) on the geared lid (8)
and rotate it clockwise until it is fixed.
–
To connect the unit to the mains, insert the
power cord plug into the mains socket.
–
Set the required speed with the control knob
(5).
–
To switch the blender on, press and hold the
button (4).