Vitalcare 506DN3, Руководство по обслуживанию

Страница: 97 / 254

Criticare Systems, Inc. VitalCare
TM
506N3 Series Service Manual Page 6-7
Section 6 —Service Testing & Calibration
Setup
1. Turn off the power and disconnect the AC (Mains) power.
2. Place the monitor on a ESD protected workbench. Observe all
ESD protection procedures as described in “Electrostatic
Discharge Protection” in Section 7.
3. Connect the download cable to the DB-9 serial connection of
the monitor’s front bezel. Connect the other end to the DB-9
serial port of the computer.
4. Open the service tool on the computer. Select Start > Programs
> CSI NIBP Service > NIBPSvc (or click on the shortcut on the
PC desktop). Close the disclaimer dialogue box.
5. Select COM1 for the port.
For laptops using a USB adapter , select COM 4 or an alternate
COM port as necessary.
6. Select 506N3 NIBP MODULE in the drop-down menu box.
Figure 6-3: Select the COM Port and Model
7. Plug the monitor back to the AC (Mains) source.
8. Power up the unit while pressing the NIBP START/STAT/STOP
key.
9. On the display of the unit, verify that the message CHECKING
FOR NIBP TOOLS…. appears.
10.Select the Connection from the drop-down menu. Select Open
in Service Mode .
Figure 6-4: Select Open in Service Mode
11.If communication has been established, the following screen
should appear. When this message appears, communication
with the PC is established.
Figure 6-5: Communication Established
5 6