Vitalcare 506DN3, Руководство по обслуживанию

Страница: 77 / 254

Criticare Systems, Inc. VitalCare
TM
506N3 Series Service Manual Page 5-15
Section 5 —Preventative Maintenance
6. If the monitor has Temperature: Connect the FasTemp or
TurboTemp leakage cable to the RA terminal on leakage tester.
Record the measurement on the check sheet or attach print out
of the acceptable test result to the check sheet and test.
Configure the leakage tester to measure the patient connection
to GND leakage. (Dynatech 232D: MODE = ECG, LEADS = ALL
TO GND).
• Normal Polarity (<10uA)
• Normal Polarity, Open Ground (<50uA)
7. If the monitor has Temperature: Configure the leakage tester to
measure patient interlead leakage. (Dynatech 232D: MODE =
ECG, LEADS = RA-LA).
• Normal Polarity (<10uA)
• Normal Polarity, Open Ground (<50uA)
• Hazardous voltage are present on the test leads. Do not touch
these leads or the monitor while performing this test.
8. If the monitor has DOX SpO
2
: Connect the DOX SpO
2
leakage
cable to the LA terminal on leakage tester.
If the monitor has Nellcor SpO
2
: Connect the Nellcor SpO
2
leakage cable to the LA terminal on leakage tester.
Record the measurement on the check sheet or attach print out
of the acceptable test result to the check sheet and test.
Configure the leakage tester to measure patient isolation.
(Dynatech 232D: MODE = ECG, LEADS =ISOLATION TEST)
• Normal Polarity (<50uA) Press the isolation button.
9. If the monitor has Temperature: Connect the FasTemp or
TurboTemp leakage cable to the RA terminal on leakage tester.
Record the measurement on the check sheet or attach print out
of the acceptable test result to the check sheet and test.
Configure the leakage tester to measure patient isolation.
(Dynatech 232D: MODE = ECG, LEADS =ISOLATION TEST)
• Normal Polarity (<50uA) Press the isolation button.
WARNING
! !