Vislink Strata RX, Техническое справочное руководство

Страница: 86 / 186

Advanced Operation 5-10
Strata RX
Technical Reference Manual
5.4 Programming the Configuration
Into the RX
Once the new configuration has been created and saved to a
file, you can program it into the RX System. To program a
configuration into an RX System, follow the steps below.
Already Connected?
If your RX is already powered, and the
Configurator is already running, skip to step 5.
1. Connect the RX to power and to your PC.
a. Connect the RXU to the RCU with coaxial cable.
b. Connect power through the front panel connectors
on both the RXU and RCU.
c. Connect the RS-232 cable to the RS-232
connector on the RXU (or RCU if present).
If you are configuring an RXU and RCU that are
connected, you only need to connect the RS-232
cable to one of them.
2. Power up both the RXU and RCU.
3. Start the RX Configurator.
Double-click the icon on your PC’s Desktop:
4. The Main Page appears (see Figure 5-12).
Figure 5-12: Main Page - No Radio Connected
5. Be sure the desired configuration is on-screen.
If necessary, load it in from a file. See Section 5.3.2 on
page 5-4.
6. Click on the Connect to Radio button.
This will establish communication with the Strata RX.
See Figure 5-12.
The
Connect to Radio
button will change its label to
Disconnect
.
7. The Main Page updates to show the hardware
detected.