Vislink Strata RX, Техническое справочное руководство

Страница: 113 / 186

Installation 6-17
Strata RX
Technical Reference Manual
6.11 Powering Up
When the wiring and mounting are completed, it is time to power
up the RX. As good practice, you should make a final check
before power is applied.
6.11.1 Checks before power-up
Here are your final pre-power-up checks:
• Double check to be sure all the cables are connected to
the correct receptacles.
• Make sure the connections are all fully mated and locked.
WARNING
Be sure the power being supplied matches
the power required by the equipment.
6.11.2 Initial power-up
Now you are ready to apply power:
1. Turn on the power.
Remember to turn on the Power Switches on
both
the
RXU and RCU.
If you are using DC Power on Coax to power the RXU,
be sure the DC On Coax switch on the RCU is set to
ON. Also check the Monitor Screens to be sure the RX
is configured for
DC ON COAX
to be
ON
.
2. Check to see that:
- The front panel displays are working.
- The front panel LEDs illuminate.
- The power up sequence is normal. See Section 3.3.2
on page 3-8.
3. If everything appears to be normal, test the
performance of your RX by setting up a link and
transmitting and receiving video and audio.
If you have any problems, refer to the “Troubleshooting” chapter
to determine the cause.
6.12 Product Modifications
The product you purchased has been carefully designed and
tested, and is warranted to meet specifications when connected
and operated as described in this manual.
Note that if you modify a product without authorization from
Vislink, it may void the warranty.
For a complete Warranty statement, refer to the
Notices
section
at the front of this manual.