Vicon Surveyor 99, Руководство по установке и эксплуатации

Страница: 56 / 69

46
••••
Operation XX002 Rev 799 Surveyor99 Dome System
Verifying Proper Operation
Set up a remote keypad via RS-422/485 or a NOVA/VPS CPU via RS-422/485 or Vicoax protocol to the
Surveyor99. Power-on the control device and verify that it boots up. Set up the control device for operation
with the Surveyor99 in accordance with its Installation and Operation Manual.
For a Vicon model V1300X-RVC or V1300X-DVC keypad connected directly to the Surveyor99 or through a
CPU, use the following procedure to access Surveyor99 programming:
1. Slide the keypad’s PGM-RUN switch to the
PGM position.
2. Press the PP ENTER key; the PRESET
LED displays a blinking 0.
3. Press the 9 and 4 numeric keys in that
order.
4. Press the PP ENTER key again. The
PRESET LED display remains with the
number 94 and the monitor displays the
Surveyor99 Main Menu, as shown in
Figure 42.
5. Set up the Surveyor99 as desired using the
remote keypad. Proper operation has been
verified.
Use of the Auto-Baud
Detect Feature
Entering Preset 95 will start the Auto-Baud
Detect feature. It allows the Camera Dome to
detect a new baud rate from the host controller
without having to cycle AC power. This feature
is especially useful when the Camera Dome
will be set up remotely at one baud rate and
installed into a system having a different baud
rate. See Figure 43.
After configuration of Surveyor99 is complete,
set the baud rate for the new host system
before powering down and disconnecting as
follows:
1. Slide the keypad’s PGM-RUN switch to the
PGM position.
2. Press the PP ENTER key; the PRESET
LED displays a blinking 0.
3. Press the 9 and 5 numeric keys in that
order.
Figure 42
Main Menu
Figure 43
Auto-Baud Detect Screen