Vicon Surveyor 99, Руководство по установке и эксплуатации

Страница: 43 / 69

XX002 Rev 799 Surveyor99 Dome System Wiring
••••
33
WARNING: If Vicoax mode is being used, DO NOT wire TB3 for control, as this will cause the Camera
Dome Program to lock up upon power-up.
6. Reinstall the Terminal Blocks TB1 and TB3 into
the Communication Power Supply Board at the
proper block frames.
7. Install the video BNC cable connector to the
Communication/Power Supply Board’s mating
BNC Connector.
8. Plug in all RJ-45 cable connectors to their
corresponding mating connectors J1 and J3.
WARNING: Failure to insert the RJ-45
Connectors into the correct mating
connectors can cause damage to
the Communication Power Supply
Board upon power-up.
9. Place each cable into the
Enclosure’s Cable Clamp (for
the Outdoor version, under the
Fan Bracket as shown in Figure
30.) The Safety Cord should
now provide sole support of the
Surveyor99 and the cables
should be slack and
comfortably run to their
connectors. Push any
remaining cable back through
the top of the Housing until the
cabling comfortably passes
directly from the Cable Clamp
(Fan’s Bracket) to the top of the
Housing.
Figure 29
Indoor Pendant Mount Cable Installation
Figure 30
Outdoor Pendant Mount Cable Installation