Vicon Surveyor 99, Руководство по установке и эксплуатации

Страница: 16 / 69

6
••••
Installation XX002 Rev 799 Surveyor99 Dome System
8. Insert Camera Drive into Enclosure, carefully aligning Captive Screws and mating standoffs. Tighten 3
Captive Screws.
9. Attach Lower Dome and power-up. Refer to the Maintenance Section for Lower Dome handling.
This Surveyor99 is shown with typical wiring and configuration using Flexible Conduit. See Figure 4. The DIP
switches are set as follows:
DIP SWITCH S1 (Surveyor99 address):
1 - ON, 2 - OFF, 4 - OFF, 8 - OFF, 16 - OFF, 32 - OFF, 64 - OFF, 128 - OFF (THIS IS ADDRESS 1)
DIP SWITCH S2 (Surveyor99 configuration):
1 - ON (NTSC), 2 - OFF (VPS), 3 - OFF (DUPLEX), 4 - OFF (RS-422), 5 through 8 - OFF (not used)
Figure 4
Close-Up View - In-Ceiling Configuration with Flexible Conduit