Vicon Surveyor 99, Руководство по установке и эксплуатации

Страница: 29 / 69

XX002 Rev 799 Surveyor99 Dome System Installation
••••
19
NOTE: Failure to loop the cables can prevent later removal of the Camera Drive from the Enclosure.
9. Configure the Surveyor99 communication and address DIP Switches as follows:
a) If RS-422 Mode will be used:
1. Set switches 1 - 8 on DIP Switch 1 (S1) to Surveyor99’s address as specified in Table 2. All
addresses between 0 and 255 are valid (address 0 is the same as camera number 256).
2. Set switch 1 on DIP Switch 2 (S2) to the appropriate video mode (PAL/OFF or NTSC/ON).
Figure 17
Close-Up View - In-Ceiling Configuration with Cables