Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 26 / 62

20
••••
Installation XX100-00-01 Rev 202 Surveyor1000 Camera Dome System
2. Set switch 2 on DIP Switch 2 (S2) to the ON position (Vicoax mode).
3. Set switch 3 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
4. Set switch 4 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
NOTE: DIP Switches labeled ON or CLOSED and OFF or OPEN have the same meaning.
14. With the Surveyor1000 hanging from the Housing, verify that the wiring resembles
the technique of Figure 14a.
WARNING: Cables having excessive slack can cause damage to the Surveyor1000
when installed into the Housing.
15. With the Surveyor1000 oriented as shown in Figure 14b, lift it so that it is flush with
the Housing.
16. Turn the Surveyor1000 counterclockwise (looking up) until the arrow on the
Installation Label is aligned with the arrow on the inside of the Housing as shown in
Figures 14c and 14d.
17. Push the Surveyor1000 straight up into the Housing as shown in Figure 14e. Verify
that the 2 slots on the Surveyor1000 snap into the Housing clips. Do not use
excessive force. In the event that it does not snap easily, remove the Surveyor1000
and verify proper cabling.
18. Lift the Lower Dome up to the
Surveyor1000 and press in
it’s Safety Cord Plug into the
hole provided on the inside of
the Enclosure to anchor the
Lower Dome. See Figure 15.
19. Holding the Lower Dome, line
up the 2 molded tabs on the
Lower Dome with the 2
recesses on the inner
Enclosure. There are only 2
ways to align it. Push the
Lower Dome up and verify
that it snaps into place on
both sides.
20. Proceed to the Operation
Section of this manual.
a
b
c
d
e
Figure 14
Pendant Mount Final
Assembly
Figure 15
Indoor Lower Dome Installation