Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 38 / 62

32
••••
Wiring XX100-00-01 Rev 202 Surveyor1000 Camera Dome System
Using the Optional Alarm Kit
(S2000-ACL)
This optional Alarm Kit consists of a Termination
Box and RJ-45 Cable. It is used to assist in using
connector J2, an RJ-45 socket on the Power
Supply/Communication Board. Connector J2
provides access to the 4 alarm inputs. The RJ-45
Cable has one male end, which plugs directly into
connector J2, and color-coded open wires on the
other, which connect to the Termination Box. Since
the RJ-45 cable is 10 feet (2.5 m), the Termination
Box must be mounted within the vicinity of the
Surveyor1000. Use of this kit is similar to the
Accessory Kit.
The Termination Box provides a convenient
connection from open wires to open wires. After
the cable is passed through the Cable Fitting
(ceiling-mounted Surveyor1000 only), connect it to
Termination Box’s terminals.
When the cover of the Termination Box is
removed, the pre-wired terminal block will
resemble Figure 28. Feed the Control Cable into
the side and connect each wire to the appropriate
screws. Use Table 1 to reference the proper color-
to-signal code. Do the same with the cable from
the Surveyor1000. Figure 28 is shown wired for a
typical Surveyor1000 using ALARM 1 and ALARM
2.
Figure 28
Use of the Optional Alarm Kit
WIRE COLOR PIN NUMBER
(in RJ-45 connector on
opposite end)
SIGNAL NAME
(alarms)
WHITE/GREEN 1 ALARM 1
GREEN 2 VSSA
WHITE/ORANGE 3 ALARM 2
BLUE 4 VSSA
WHITE/BLUE 5 ALARM 3
ORANGE 6 VSSA
WHITE/BROWN 7 ALARM 4
BROWN
8 VSSA
Table 1
Alarm Signal Wire Color Code