Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 22 / 62

16
••••
Installation XX100-00-01 Rev 202 Surveyor1000 Camera Dome System
3. Set switch 2 on DIP Switch 2 (S2) to the OFF position (VPS/NOVA mode).
4. Set switch 3 on DIP Switch 2 (S2) to the appropriate communication mode (SIMPLEX/DUPLEX).
5. Set switch 4 on DIP Switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-485)
position as specified in Table 3.
b) If Vicoax Mode will be used:
1. Set switch 1 on DIP Switch 2 (S2) to the appropriate video mode (PAL or NTSC).
2. Set switch 2 on DIP Switch 2 (S2) to the ON position (Vicoax mode).
3. Set switch 3 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
4. Set switch 4 on DIP Switch 2 (S2) to either position, as it does not affect Vicoax protocol
operation.
NOTE: DIP Switches labeled ON or CLOSED and OFF or OPEN have the same meaning.
10. Lift the Lower Dome up to the
Surveyor1000 and line up the molded tabs
on the Lower Dome with the recesses on
the inner Enclosure. There are only 2 ways
to align it. Refer to Figure 10.
11. Insert the Plug on the Safety Cord into the
Hole on the Surveyor1000. Push the Lower
Dome up into the Surveyor1000. Verify that
it snaps into place on both sides. The upper
edge of the Lower Dome should be flush
with ceiling plane.
12. Proceed to the Operation Section of this
manual.
Figure 10
Final Assembly, Ceiling Mount Version