Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 29 / 62

XX100-00-01 Rev 202 Surveyor1000 Camera Dome System Installation
••••
23
4. Set switch 3 on DIP Switch 2 (S2) to the OFF position (SIMPLEX/DUPLEX).
5. Set switch 4 on DIP Switch 2 (S2) to the appropriate communication protocol (RS-422 or RS-
485).
b) If Vicoax Mode will be used:
1. Set switch 1 on DIP Switch 2 (S2) to the appropriate video mode (PAL or
NTSC).
2. Set switch 2 on DIP Switch 2 (S2) to the ON position (Vicoax mode).
3. Set switches 3 and 4 on DIP Switch 2 (S2) to either position, as they do
not affect Vicoax protocol operation.
NOTE: DIP Switches labeled ON or CLOSED and OFF or OPEN have the same
meaning.
15. With the Surveyor1000 hanging from the Housing, verify that the wiring resembles
the technique of Figure 17a.
WARNING: Cables having excessive slack can cause damage to the
Surveyor1000 when installed into the Housing.
16. With the Surveyor1000 oriented as shown in Figure 17b, lift it so that it is flush
with the Housing.
17. Turn the Surveyor1000 counterclockwise (looking up) until the arrow on the
Installation Label is aligned with the arrow on the inside of the Housing as shown
in Figures 17b and 17c.
18. Push the Surveyor1000 straight up into the Housing as shown in Figures 17d and
17e. Verify that the 2 slots on the Surveyor1000 snap into the Housing clips. Do
not use excessive force. In the event that it does not snap easily, remove the
Surveyor1000 and verify proper cabling.
19. Lift the Lower Dome up to the Surveyor1000 and press in its Safety Cord Plug
into the hole provided on the inside of the Enclosure to anchor the Lower Dome.
20. Holding the Lower Dome, line
up the 2 molded tabs on the
Lower Dome with the 2
recesses on the inner
Enclosure. There are only 2
ways to align it. Push the
Lower Dome up and verify that
it snaps into place on both
sides. See Figure 18.
21. Tighten the 4 Trim Ring
Screws to hold the Lower
Dome in place. Verify proper
orientation of the Grommet.
22. Proceed to the Operation
Section of this manual.
a
b
c
d
e
Figure 17
Pendant Mount
Final Assembly
Figure 18
Outdoor Lower Dome Installation