Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 8 / 62

2
••••
Introduction XX100-00-01 Rev 202 Surveyor1000 Camera Dome System
Accessory Kits
There are 3 different Accessory Kits included with the 3 basic configurations of Surveyor1000; ceiling, indoor
pendant and outdoor pendant. These kits provide the necessary items during installation as follows:
Ceiling Mount Version
DESCRIPTION QUANTITY
Termination Box with RJ-45 female connector 1
Cable, RJ-45 male to RJ-45 male, 10 ft (2.5 m) 1
RS-485 Termination Jumpers
3
Scribe for Ceiling Tile 1
Fitting, 0.5 in (12.7 mm) Romex with locknut
1
Indoor/Outdoor Pendant Mount Version
DESCRIPTION QUANTITY
Termination Box with RJ-45 female connector 1
Cable, RJ-45 male to RJ-45 male, 10 ft (2.5 m) 1
RS-485 Termination Jumpers
3
Outdoor Pendant Mount Version (only):
DESCRIPTION QUANTITY
Teflon Tape, 0.5 in (12.7 mm) X 60 in (1524 mm) roll
1
NOTE: Teflon Tape is included in the Outdoor Housing Accessory kit.
The Termination Box and RJ-45 Cable Assembly is included to be used for control and relay connections in
connector J3 or alarm connections in connector J2. Refer to the Wiring Section of this manual for details on
using this supplied Termination Box and Cable Assembly. The supplied Strain Relief Fitting is used as an
alternate means of providing support for cables on the In-Ceiling Mount Model when Flexible Conduit Pipe will
not be used. Refer to the In-Ceiling Mount Model sub-section of the Installation Section for details on installing
this fitting. The RS-485 jumpers are provided to configure the RS-485 protocol and enable daisy-chaining of
Surveyor1000. The Teflon Tape is used for sealing the end of the 1.0-inch NPT Pipe on the Outdoor Pendant
Model. Refer to the Outdoor Pendant Model sub-section of the Installation Section for details on applying the
tape.
Unpacking and Inspection
All Vicon equipment is tested and inspected before leaving the factory. It is the carrier’s responsibility to
provide suitable delivery.
Inspect the cartons upon delivery and, if damage is present, make detailed notes on the carrier’s bill. Then,
obtain the carrier agent’s signature and file a damage claim as soon as possible.
Open the cartons and inspect the equipment for damage. Save the cartons and packing material. If damage is
present, contact the carrier and file a damage claim immediately. If the equipment must be returned for repair,
follow the instructions in the Shipping Information Section of this manual.