Vicon surveyor 1000, Руководство по установке и эксплуатации

Страница: 36 / 62

30
••••
Wiring XX100-00-01 Rev 202 Surveyor1000 Camera Dome System
Using the Accessory Kit’s
Termination Box and RJ-45 Cable
for Wiring
The Termination Box and RJ-45 Cable are
provided to assist in using connector J3.
Connector J3 is required to access the internal
relay and is an alternate connector for access to
the Surveyor1000’s control signals. The RJ-45
Cable has two male ends which plug directly into
connector J3 and the Termination Box. Since the
RJ-45 cable is 10 feet (2.5 m), the Termination
Box must be mounted within the vicinity of the
Surveyor1000.
The Termination Box provides a convenient
adapter from the RJ-45 connector to individual
wires. After the cable is passed through the Cable
Fitting (ceiling-mounted Surveyor1000 only),
connect it to Termination Box’s jack.
When the cover of the Termination Box is
removed, the pre-wired terminal block will
resemble Figure 24. Feed the Control Cable into
one of the sides and connect each wire to the
appropriate screws. Figure 26 is shown wired for
typical Surveyor1000 duplex operation with no
relay.
NOTE: Upon initial installation of a ceiling-
mounted Surveyor1000, it is recommended to
pass this RJ-45 Connector through the fitting first.
After this, the remaining connectors that do not fit
through the fitting must be cut off and terminated
later.
NOTE: Use only the supplied Vicon RJ-45 cable or
shielded equivalent.
Recommended Use of the Termination
Box with Flexible Conduit
If it is necessary to keep the control cable within
Flexible Conduit, it will be necessary to obtain a
Break-Out Box. The Termination Box is then
mounted inside it and can have Flexible Conduit
run to it from both sides, as shown in Figure 25.
This method maintains a Flexible Conduit cover
over all cables and provides secure mounting of
the Termination Box.
Figure 24
Use of Accessory Kit Cabling
Figure 25
Use of a Break Out Box for Termination Box
Mounting